07-19-2019 10:53 AM - edited 07-19-2019 11:04 AM
Hello All,
We have an IR829GW router. I need to use it as a typical old school NAT router such that whatever devices are behind it use a NAT IP for the traffic that's going outbound ( For instance Internet access). I have looked in the config guide and couldn't find any instructions regarding this. Secondly, this device has a hyper-visor style architecture. Can someone educate me what is the purpose of creating a VM on such devices ? What would be the use-case ?
My internal devices are connected to a L2 switch which in-turn will have a uplink from one of the interfaces of this IR829. My requirement is that all internet bound traffic originating from these internal devices should be Dynamic NAT'd or PAT based on whatever NAT IP i assign.
THanks
Solved! Go to Solution.