09-27-2019 06:06 AM
Hello community,
I am struggling to get Inter-VLAN-Routing running on a WS-C2960L-48PS-LL, Version 15.2(7)E0a.
For testing-purposes I created two SVIs with IP-addresses, 2 VLANs and enabled "ip routing".
I followed this guide provided by cisco:
"show ip route" outputs:
Sep 27 11:10:40.179: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan3, changed state to upte
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route, H - NHRP, l - LISP
a - application route
+ - replicated route, % - next hop override, p - overrides from PfR
Gateway of last resort is not set
10.0.0.0/8 is variably subnetted, 4 subnets, 2 masks
C 10.10.2.0/24 is directly connected, Vlan2
L 10.10.2.1/32 is directly connected, Vlan2
C 10.10.3.0/24 is directly connected, Vlan3
L 10.10.3.1/32 is directly connected, Vlan3
Unfortunately I can't ping between VLANs. SVIs are up and reachable, but clients in VLAN aren't. Some datasheets state that this switch supports routing others don't.
I am curious if someone got routing running on this switches.
Thanks in advance
Kind regards
Simon