Hi,
We recently implemented Cisco 3850 switches and we are observing huge discards on the interfaces. I have below default configuration but not seeing anywhere applied.
show policy-map
Policy Map system-cpp-policy
Class system-cpp-police-data
police rate 200 pps
conform-action transmit
exceed-action drop
Class system-cpp-police-sys-data
police rate 100 pps
conform-action transmit
exceed-action drop
Class system-cpp-police-sw-forward
police rate 1000 pps
conform-action transmit
exceed-action drop
Class system-cpp-police-multicast
police rate 500 pps
conform-action transmit
exceed-action drop
Class system-cpp-police-multicast-end-station
police rate 2000 pps
conform-action transmit
exceed-action drop
Class system-cpp-police-punt-webauth
Class system-cpp-police-l2-control
Class system-cpp-police-routing-control
police rate 1800 pps
conform-action transmit
exceed-action drop
Class system-cpp-police-control-low-priority
Class system-cpp-police-wireless-priority1
Class system-cpp-police-wireless-priority2
Class system-cpp-police-wireless-priority3-4-5
Class system-cpp-police-topology-control
Class system-cpp-police-dot1x-auth
Class system-cpp-police-protocol-snooping
Class system-cpp-police-forus
Class system-cpp-default
Policy Map port_child_policy
Class non-client-nrt-class
bandwidth remaining ratio 10
Need suggestion to fix the issue.
Regards,
Santosh
