04-30-2020 02:05 AM - edited 04-30-2020 02:06 AM
Hi volks,
did someone used the 2 PoE-Ports at the Firepower 1010 with FTD 6.6 and FDM?
I tryed to connect an AP1815I to Eth1/7. The AP gets stuck in a reboot cycle because he didnt get enough power via PoE (blinking amber-red-green then turning off).
The cli in FDM says:
> show power inline Interface Power Class Current (mA) Voltage (V) --------- ----- ----- ------------ ----------- [..] Ethernet1/7 ON 6 30.00 53.00 Ethernet1/8 OFF -1 0.00 0.00
i think the classifcation as Class 6 might be the Problem, because the AP do 802.1af and class 6 is for 802.3bt devices.
To be sure, that the Problem isn't caused by the AP i connected it to a Cat3850 with PoE. At this Switch the AP is detected correct and doesn't reboot.
AcB#sh power inline g7/0/48 Interface Admin Oper Power Device Class Max (Watts) --------- ------ ---------- ------- ------------------- ----- ---- Gi7/0/48 auto on 8.4 AIR-AP1815I-E-K9 0 30.0