Hi, Community,
I am still at learning stage, highly appreciate if someone help me in static routing. My static routing in packet tracer is not working with attached topology. The Router_1 does not shows any static routes though I've configured and same thing happened in Router_3 could not see the static routing when I run
sh ip route
but I could see the static routing in Router_2 routing table.
From the PC1 I could ping the R2 int ip of .201 but outbound failed
host not reachable
returned from 192.168.1.1. Same thing happened when i did ping from the PC2, it only reached R2 int IP of .109. I am really not sure where i did wrong or missed any commands.
Thank you in advance..
Regards,
draj
