I've created certain vlans and allowed them on trunk but not all the allowed vlans are shown in 'vlans allowed and active in management domain' list because of which I cannot ping the different devices connected to different switch but which are in the same vlan. From below information I am only able to ping the devices within the vlans that are in the list of allowed and active vlans in management domain. What is the reason and how can I communicate with all the devices of respective vlans that are allowed on trunk? Below is 'show interface trunk' result.
SW-1#sh int trunk
Port Mode Encapsulation Status Native vlan
Fa0/2 on 802.1q trunking 1
Fa0/3 on 802.1q trunking 1
Port Vlans allowed on trunk
Fa0/2 10,20,30,40,99
Fa0/3 10,20,30,40,50,99
Port Vlans allowed and active in management domain
Fa0/2 10,40,99
Fa0/3 10,40,50,99
Port Vlans in spanning tree forwarding state and not pruned
Fa0/2 10,40,99
Fa0/3 10,40,50,99
