02-23-2021 01:24 AM
Hello,
during SMU installation on NCS5501-SE, IOS XR 7.1.2 I almost run out of a disk space. Here is the warning
%HA-HA_WD-3-DISK_ALARM_ALERT : A monitored device / ( rootfs:/ ) is above 80% utilization. Current utilization = 85. Please remove unwanted user files and configuration rollback points.
SMU installation finished with the following message:
Node 0/0/CPU0 encountered error(s) during operation. Please check 'show install log 71 detail' for error details -------------------------------------------------------------------------------- Error stack for location 0/0/CPU0 1# on / Available disk space(including additional buffer 104857600) 519483392 is not sufficient for rpm installation of archive size 481421256 2# failed to load files from ldpath (new) Please collect 'show tech-support install one-showtech' from XR and 'show tech-support ctrace' from Admin and pass this information to your TAC representative for support. -------------------------------------------------------------------------------- Feb 18 22:14:07 activate operation completed for all package(s) Feb 18 22:14:09 Action 2: install activate action completed, however 1 node(s) encountered problems and should be reloaded to recover.
Here is the "show media location all" output
RP/0/RP0/CPU0:ios#show media location all Fri Feb 19 13:52:52.721 UTC
Media Information for node0_RP0_CPU0. ---------------------------------------------- Partition Size Used Percent Avail rootfs: 3.9G 2.0G 53% 1.8G apphost: 3.7G 106M 3% 3.4G /dev/sde 969M 429M 48% 474M harddisk: 5.6G 560M 11% 4.8G log: 459M 56M 14% 369M config: 459M 2.5M 1% 422M disk0: 2.0G 6.0M 1% 1.9G disk2: 15G 2.8G 20% 12G --------------------------------------------------- rootfs: = root file system (read-only) log: = system log files (read-only) config: = configuration storage (read-only) Media Information for node0_0_CPU0. ---------------------------------------------- Partition Size Used Percent Avail rootfs: 3.9G 3.1G 85% 587M apphost: 3.7G 106M 3% 3.4G /dev/sde 969M 429M 48% 474M harddisk: 5.6G 560M 11% 4.8G log: 459M 60M 14% 366M config: 459M 796K 1% 424M disk0: 2.0G 4.6M 1% 1.9G --------------------------------------------------- rootfs: = root file system (read-only) log: = system log files (read-only) config: = configuration storage (read-only)
It is obvious I need to free up some disk space to continue with patching. Any advice on what and where to free up?
Best Regards,
Peter