Dear all,
Do you have any recommendation how to configure 9800 series to have possibility on certain APs to have one of the bands disabled? Let's say you want all APs at one location to be 5GHz only (therefore 2.4 to be disabled) apart of manually go to each and every AP and disable this band?
I played around with Custom RF Policy, but there you can either enable or disable this policy (Status = Enable / Disable), however if such policy e.g. for 2.4GHz is disabled, and you assign it in RF Tag, then on the AP level it looks as Admin Status = Enabled, Operational Status = Down.
But if you just disable 2.4 GHz interface directly on AP level you can see Admin Status = Disabled, Operational Status = Down.
Believe that important is Operational Status (Up / Down) and for this purpose Admin Status doesn't really matter.
However want to ask if there is better and consistent way to do so and achieve one interface is disabled on ALL APs with assigned RF Tag. I see only way, is to define custom RF policy, keep it disabled and map this policy within RF Tag. But then from view perspective it might be a bit misleading in 9800 WebUI.
Thanks
Martin
