Hi,
Is it possible to use type 6 encryption on a C1000-8P-E-2G-L?
When I try to configure it as below not even the command is recognized...
switch-01#conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch-01(config)#key ?
% Unrecognized command
switch-01(config)#key config-key password-encrypt
^
% Invalid input detected at '^' marker.Details about the switch:
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 10 C1000-8P-E-2G-L 15.2(7)E6 C1000-UNIVERSALK9-M
