11-16-2022 07:24 AM
I purchased a 3 pack of 140ac access points with plans of buying up to 10 more to replace my current enGenius AP network. I connected the first unit to my network and waited for initial config to complete, then proceeded to follow instructions to configure the remaining setup of the device. Once complete, I connected the second unit, then waited for hours but the device would never get past the green, amber, red flashing lights and no further configuration could be completed. I have reset and repeated this process 5 times, always with the same result, the first one sets up without issue, but the second will never fully complete the initial setup. What am I doing wrong here?