cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Mobility tunnel between 5508[Anchor] - 9800 [Foreign]

Trying to set up Mobility tunnel between 5508[Anchor] - 9800 [Foreign] 

5508 is already on the IRCM supported version as follows AIR-CT5500-K9-8-5-182-104.aes, I can't see any option under GUI/CLI for security mobility, as i understood on 9800 it will be enabled by default and opposite side required the same settings.

EDIT: Figured it out, under Controller > Mobility configuration > Enable New Mobility (converged access) was Enabled, disabled that option (It will reboot controller) and I can see option to enable secure mobility option under mobility groups & Tunnel came up successfully.

 
 
 

download.png

 

Who Me Too'd this topic