cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

#Threat-Detection Basic-Threat on FTD

Monadnock
Beginner
Beginner

 Hi, I have an audit that is picking up on the threat-detection CLI from an FTD show run and asking to change this:

#threat-detection basic-threat

to

#threat-detection advanced-threat

I obviously can't configure that within CLI and I don't see anywhere in the GUI to change threat-detection level to basic. I'm also a bit confused on all of the commands there - are they remnants of ASAs? Is packet rate limiting not done via Network Access Policy and/or the advanced tab under Access Control Policy?

Thanks!

Who Me Too'd this topic