Hi,
I hstacked 4 Cisco C1000-48P-4X-L switches for testing. Then, trying to use them separately, I reset one of them through boot mode. After that I put the config on the switch. When I unplugged the power and plugged it back in, the switch wouldn't boot. I changed the IOS version of the switch, I also installed the latest one. But it didn't help. It gives the following error.
Front-end Microcode IMG MGR: Programming device 0...
IMG MGR I2C write failedError : Not able to send packet sizew
IMG MGR I2C write failedError : Not able to send packet size
% Front-end Microcode IMG MGR: address 0, failed to switch to bootloader mode.
% Front-end Microcode IMG MGR: unable to program device
RE Msg payload send failed
RE Msg payload send failed
INIT: Pp init completed.
RE Msg payload send failed
RE Msg payload send failed
RE Msg payload send failed
INIT: ASIC 0 phases init completed.
INIT: ASIC 1 phases init completed.
INIT: phases init completed.
INIT: features init completed.
POST: PortASIC Port Loopback Tests : Begin
RE Msg payload send failed
POST: PortASIC Port Loopback Tests : End, Status Passed
POST: ACT2 Authentication : Begin
POST: ACT2 Authentication : End, Status Passed
**RE Polling Disabled***
Waiting for Stack Master Election...
POST: Thermal Tests : Begin
POST: Thermal Tests : End, Status Passed
Election Complete
Switch 1 booting as Master
RE Msg payload send failed
RE Msg payload send failed
Initializing Device Manager...
Waiting for Port download...Complete
RE Msg payload send failed
rem_i2c_get_reply: Reached max retries in getting reply
RE Msg payload send failed
rem_i2c_get_reply: Reached max retries in getting reply
RE Msg payload send failed
rem_i2c_get_reply: Reached max retries in getting reply
RE Msg payload send failed
rem_i2c_get_reply: Reached max retries in getting reply
RE Msg payload send failed
rem_i2c_get_reply: Reached max retries in getting reply
RE Msg payload send failed
rem_i2c_get_reply: Reached max retries in getting reply
