GoodDay to All,
Im using a 1750 router, and then i upgrade it to higher version, after
then i reload it, the problem it does not goes to start-up mode or
even the rommon mode,not enough memory to load the image, it always
rebooted after the self-decompressing image,
I try to stop it using the CTRL+Break, but it doesn't work.
Here are the error message.
Smart Init is disabled. IOMEM set to: 20
Memory required: 31637548 bytes, Memory available: 25165824 bytes
INSUFFICIENT MEMORY TO LOAD IMAGE!
The difference between Memory required and Memory available is the additional
memory you need to run the router. Alternately, use a smaller image; this
may cause the memory requirement to decrease, and may allow you to at least
use the router with reduced functionality until you get more memory.
*** System received a Software forced crash ***
signal= 0x17, code= 0x200, context= 0x8000620c
PC = 0xffffffff, Vector = 0x200, SP = 0xffffffff
?
System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
C1700 platform with 24576 Kbytes of main memory
program load complete, entry point: 0x80008000, size: 0x6b4628
Self decompressing the image : #################################
###############################################################
################# [OK]
Smart Init is disabled. IOMEM set to: 20
Thanks,
Lester
