We are trying to configure a new subinterface g0/0.1725 on both our routers.
This will allow a few devices to use the 192.168.172.x range
I have configured the subinterfaces on the primary and the failover router.
However they are not passing HSRP information.
Router A is connected to switch A
and Router B is connected to switch B.
Switches A and B are trunked together.
We have 2 vlans configured on the switches. Both are passing HSRP information.
Do I need to configure vlan 1720 so the information will pass on the new subnet
we are trying to configure to pass HSRP?
