ASR1001-X-PWR-AC Router redundancy Link

[adhill1980]

I have a ASR1001-X-PWR-AC router setup with a primary Link. I am trying to setup a redundancy link on port GE2. The specs on the fiber is as followed: FSD Mode=SFP Speed 1000 Duplex Full. I need the line commands to make this changes. I type the following at command prompt:

enable-config t - int gigabitethernet 0/0/2. The command speed and duplex is not recognized.

The connection is a fiber hand off.

Thanks

Anthony Hill

adhill80@hempsteadcitytx.com

979 221 7489

City of Hempstead

Router SN# LIT19380F2J

[Mark Malone]

Hi

its fibre port so you cant set the 1000/duplex because its that by default , so it will be 1000/duplex ,check the show int g0/0/2 when the sfp and cable is in

what sfp are you using