Re: Best scenario for PtP bridge with RV0XX

Alejandro Gidi · ‎04-20-2012

Dear gurus

We would much appreciate your input for a headachless join of two networks.

Due to bandwith requirements, we need to join a network with an RV016 to a network with an RV082 via a point to point air bridge. (VPN over adls was not cutting it) fortunatelly there is line of sight.

We would appreciate if you could advice the propper, procedure.

The info

LocationA LocationB

RV016 RV082

WAN1 ADSL modem WAN1 ADSL Modem

WAN2 DedicatedIP modem WAN2 Free

WAN3..7 free

192.168.0.1 192.168.1.1

255.255.255.0 255.255.255.0

DHCP DHCP

Servers on LAN Servers on LAN

We need LAN-B endpoints to be able to reach servers on location A and viceversa

We pre configured two point to point radios for the tower people to install. (we could change this configs)

Topology (crude sketch)

http://screencast.com/t/JoLKCvhoFO

Our questions: best port to plug the radios into the RVs WAN ports? switch ports? What rules or static routes need to be created?

We do not wish to change the IP clases/subnets if possible. All suggestions, pointers and ideas are welcomed.

looking forward to this.

Alejandro Gidi · ‎04-21-2012

Any ideas? bump

Sent from Cisco Technical Support iPad App

Alejandro Gidi · ‎04-27-2012

Hello again

We got the point to point delivered.

The radio on location A is plugged to a switch port on the RV016

The radio on location B is plugged on WAN2 on the RV082, which gets an IP via DHCP of LAN_A

The router on location B, 192.168.1.1 can ping 192.168.0.1 and devices in 192.168.0.XX, but devices on Location B cannot ping anything on location A

The router on location A, 192.168.0.1 cannot ping the router on location B, 192.168.0.1 nor anything on that network.

We need devices on location B 192.168.1.1~254 to be able to reach a server on location A under 192.168.0.1~254

Please advice, thanks