Help! I have an RV345 with the latest firmware and I'm having a really hard time with it. I have configured WAN1 successfully and I have been able to get remote admin management working. However, I have NOT been able to configure my 4 other public IPs and get any Access Rules or Port Forwarding working.
I added Sub-Interfaces under WAN (WAN1.1,1.2,1.3,1.4) for each of my other static Public IPs.
I noticed this obscure note when adding the WAN Sub-Interfaces:
1. Add this sub-interface to Multi-WAN table to forward the default route traffic. Or it will only forward the connected route traffic based on routing table.
So, I added each of the WAN sub-interfaces to the Multi-Wan Interface table:
I've tried creating Access Rules and Port Forwarding entries for my WAN1.x Sub-Interfaces, but neither of them seem to work. I can't even get an Access Rule for WAN1 to work to manage my WiFi AP.
Are there some Default Routes that I need to create for each of the WAN Sub-Interfaces? That wouldn't explain why I can't even port forward HTTP on WAN1 to my AP though.
Any assistance would be greatly appreciated.
-Joseph