Hello,
RV 120W Wireless-N VPN Firewall
Firmware Version: 1.0.2.6
I recently purchased a RV120W SB router. I have been working with it for almost 2 days, and my Quick VPN connections have never worked. I first created a VPN using the
VPN - VPN Basic Setup. I need for two remote people to connect.
I then read on a post that this is not necesarry to create the VPN using the Quick VPN software.
So I deleted the 2 rules that were created by the wizard and just created a Quick VPN user.
I did noticed that when the user is lieste, it says under the Enabled column, it says N/A.
I have tried editing the user but it does not give the me option to change that setting.
Is there anything i need to do in the firewall section to enable the VPN?
Any help is greatly appreciated
