04-19-2021 10:59 PM - edited 04-20-2021 10:35 PM
In the static NAT under firewall I am trying to create NAT rule where when I give the static IP in public IP range tab I am getting error as it is the WAN IP of WAN2. How can I create NAT then. Please help.
04-20-2021 07:08 AM - edited 04-20-2021 07:08 AM
If that is your WAN IP - i believe you should remove that IP and do rest of in range.
range means you doing dynamic NAT with Pool of IP address - is this what you intent to do ?
04-22-2021 09:16 PM
Hi Balaji,
Thanks. I just need to create a static NAT to make a server exposed to internet, somehow I managed to do it now.
04-22-2021 11:48 PM
Glad you able to find the solution.
04-23-2021 12:23 AM
Hi,
Can you share what is the error? Does your dual WAN functionality work? That setup should work as expected.
Regards,
Martin
04-23-2021 03:23 AM
Hi,
Earlier I was trying to expose internal server to internet via static NAT but I have only one static public IP and so that I cant attach it to static NAT rule since it is my WAN IP, so I discarded creating NAT instead I went for DMZ host where I added my internal server as DMZ host and created port triggering for HTTPS via desired WAN, so that WAN interface will accept HTTPS request and my webserver host in DMZ can be accessed from internet.
04-23-2021 04:00 AM
Hi,
Thanks for sharing and your feedback. That actually explains what the confusion was. With a single WAN IP address that is the workaround solution.
Regards,
Martin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide