Cisco RV110W supports up to 1 VPN policies

[Diego.Satizabal1]

Best regards

I'm using Cisco RV110W router to interconnect 20 branches natoinwide with a central site, however, though VPN establishes properly between one branch and central site it's not possible to add another tunnel in the RV110W to another secondary site (see picture)

In RV110W datasheet it says that this router supports up to 5 VPN tunnels, but apparently these 5 tunnels are intended to establish via QuickVPN software from a computer.

so: is there a real limit to 1 site-to-site (router-to-router) VPN with RV110W?

Thanks in advance for any help!

[Michael Swenson · Accepted solution]

Thank you for contacting Cisco,

The RV110w only supports 1 site to site tunnel

From Datasheet:

1 IPSec Site-to-Site tunnel

The RV130W will allow 10 site to site tunnels,  datasheet below:

http://www.cisco.com/c/en/us/products/collateral/routers/small-business-rv-series-routers/datasheet-c78-731522.html

Best Regards,

[Diego.Satizabal1]

Thanks for your reply Michael!