Configure RV340 Site to site DHCP relay

[Mnkassem]

I am configuring a site-to-site VPN between Cisco RV340 routers. The VPN tunnel is up, but clients at Site A cannot obtain an IP address from Site B.

Is this possible? If so, what steps are required to achieve this?

[balaji.bandi]

check relay config - (make sure VPN allowed intresting traffic using VPN)

https://www.cisco.com/c/en/us/support/docs/smb/routers/cisco-rv-series-small-business-routers/smb5708-configure-the-lan-and-dhcp-settings-on-the-rv34x-series-rout.html

[Mnkassem]

unfortunately that did not help, i added a second VLAN and configured option 82 on the remote router. still not getting an IP address. the client in Site A is not getting an IP address from RV340 router in site B