I have had a gateway to gateway bridge between my home internet (AT&T provides Uverse internet) and my office network (Birch communications, formerly cbeyond) using 2 RV042 routers for 3 years without a problem. I just purchased an RV320 router for my office because of increased VLAN functionality needs and I cannot get my home RV042 and office RV320 gateway to gateways to stay connected. If I reset my AT&T router and upgrade both RV's firmware (to the current, already installed - so essentially reinstalling the firmware) I can get my gateways to connect for a limited amount of time but then they disconnect and I cannot get them to reconnect. Office has a static IP and my home IP is by DNS resolved. My AT&T router is in passthrough mode so my RV042 is getting the public IP address. Is there an issue with connecting these 2 devices. I thought that all the RVxxx series could connect to each other via IPSec gateway to gateway tunnels. I have spent weeks now playing with this and it is driving me crazy!
Any help would be very very appreciated!
