Hi,
I have a RV220W router, WAP4410N access point, and SG300-28P switch - all on the latest firmware.
I would like to configure a guest SSID on the WAP4410N but can't seem to get it figured out.
What I've done so far is:
Create a vlan (let's say 100) on all three devices
Ensured a port on the switch and router are in trunk mode.
Configured the router to have an additional subnet to serve the new ip range
When I connect a client to the guest SSID, I can't ping the newly created subnet gateway address, and of course no internet access.
(Let's say the default internal IP range is 10.1.0.x and the guest vlan range is 10.5.0.x)
I'm hoping someone could give me a simple checklist of things that should be turned on/configured on each device.
I feel like I'm overlooking something simple.
Thanks!