Greetings.
I have problem with my WRV200 router.
There was some issues about WiFi network, so I decide to update firmware on my router from 10.1.24 to 10.1.39.
I was doing this thing via cable of course. (https).
At some moment the page change to blank. Router was working until reset, then everything goes wrong.
I can't connect via http (80) or https (443),Wifi doesn't work at all.
If I connect my computer to router it try to get ip via dhcp and don't get any ip.
When I watch at router the internet and power LED is active (I think the router is getting ip from network, but don't want to run his own dhcpd service).
Is there any chance to repair this thing without costs? Or I must put this thing into trash bin? :/ And buy new one?
Best regards,
Lukasz.
