03-15-2013 09:00 AM
Hello,
I have an RV082 10/100 8-Port VPN Router and have configured the NAT table to allow for remote users, however I've run into an issue. It seems like there is a limited number of entries that you can put in the table,10, and I need to configure about 5 more IPs.
Does anyone know a way to expand the NAT table, or alternatively recommend a different router. I would also be willing to add another router to the network, but I have little experience doing that.
Thank you.
Solved! Go to Solution.
03-20-2013 10:49 AM
Lisa Larson wrote:
Hello,
I have an RV082 10/100 8-Port VPN Router and have configured the NAT table to allow for remote users, however I've run into an issue. It seems like there is a limited number of entries that you can put in the table,10, and I need to configure about 5 more IPs.
If you are using the 1-to-1 NAT feature of RV082, the 1-to-1 NAT table supports 10 entries, each of which can be a range of IP addresses.
03-20-2013 05:25 AM
Which type of NAT are you using?
03-20-2013 10:49 AM
Lisa Larson wrote:
Hello,
I have an RV082 10/100 8-Port VPN Router and have configured the NAT table to allow for remote users, however I've run into an issue. It seems like there is a limited number of entries that you can put in the table,10, and I need to configure about 5 more IPs.
If you are using the 1-to-1 NAT feature of RV082, the 1-to-1 NAT table supports 10 entries, each of which can be a range of IP addresses.
03-20-2013 11:36 AM
Of course - thank you!!
It just wasn't quite clicking for me, but this makes so much sense.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide