ā07-04-2013 09:42 AM
Occasionally I need to open a port to one device on my network so a programmer has access to a home automation controller. Previosly I was using the RVS4000 with no problems. I would just put my port number in and tell the router what IP address the automation controller was at. I now have the RV180W and I've tried averything I can think of at this point. Any help would be gretaly appreciated!
Thank in advance
ā07-04-2013 12:22 PM
How did you do it on the rvs4000?
Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com
ā07-04-2013 02:52 PM
Thanks Samir, I finally got it. Found a document somewhere here in the forums.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide