11-27-2022 10:19 AM
Hi!
Cisco SB RV345
Firmware Version: 1.0.03.29
There is a bug on Precedence. If I change the order with precedence
WAN2 | 1 |
WAN1 | 2 |
USB1 | 3 |
USB2 | 4 |
The router continues to use WAN1 ethernet for ALL VLANs
Try with WAN1 & WAN2 enabled/disabled "Network Service Detection"
If I put on WAN1 IP with no ping reply, the router will switch the internet to WAN2.
But when I put normal IP to internet service detection, the internet goes on WAN1 again.
What's the problem? Why do I get internet over WAN1, not with WAN2?
11-27-2022 11:06 AM
if you looking for weighted preference you need to set high which one to use. as mentioned below link. ( also try to upgrade latest firmware on your device, look old I guess)
11-27-2022 11:15 AM
I'm not looking for weighted preference.
It's the latest firmware version for RV345 https://software.cisco.com/download/home/286288298/type/282465789/release/1.0.03.29
11-27-2022 11:31 AM
as per the screenshot you have selected weighted preference with dual wan.
11-27-2022 11:38 AM
Yes, and I want to use them by switching if the provider is down
11-27-2022 11:47 AM - edited 11-27-2022 11:50 AM
Are you looking active/standby ( active/active )
if you looking Active/Standby
you set WAN2 preference, and WAN1 lower preference, have you changed this config on fly? check to reboot the device and test it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide