RV042G one-to-one NAT problem

[tamtytamty]

Dear All

I purchased RV042G and setup one-to-one NAT problem to several servers. Sometimes the NAT servers lost the internet connection. My case as below

ISP provide two set Public IP Address , one modem

e.g.

set one) 100.100.1.2-6, gateway 100.100.1.1

set two) 200.200.2.2-6, gateway 200.200.2.1

I set my WAN 1 as below

IP: 200.200.2.2

Gateway: 200.200.2.1

One-to-One NAT as below

Public: 100.100.1.2 > Private: 192.168.1.2

Public: 100.100.1.3 > Private: 192.168.1.3

All computers and servers (one-to-one NAT) outbound and inbound all work fine. After several hours, only the servers (one-to-one NAT) alert internet connection broken, but the computers (non NAT) still have internet connection.

What's the problem occurs? Why only one-to-one NAT servers lost the connection? and Why only serveral hours later, the server lost the internet connection.

If I changed the WAN setting to same as subnet of the one-to-one NAT, it doesn't occur any problem.

Thanks

Noel

[tamtytamty]

Any help? thanks

[Te-Kai Liu]

ISP provide two set Public IP Address , one modem
e.g. 
set one) 100.100.1.2-6, gateway 100.100.1.1
set two) 200.200.2.2-6, gateway 200.200.2.1
I set my WAN 1 as below
IP: 200.200.2.2
Gateway: 200.200.2.1
One-to-One NAT as below
Public: 100.100.1.2 > Private: 192.168.1.2
Public: 100.100.1.3 > Private: 192.168.1.3

You might want to check with your ISP to see if the configuration you want to achieve is supported.

[Te-Kai Liu]

It would appear that the IP addresses provided by your ISP are meant for two WAN connections.

WAN 1 IP: 100.100.1.2

Gateway: 100.100.1.1

One-to-One NAT as below

Public: 100.100.1.3 > Private: 192.168.1.2

Public: 100.100.1.4 > Private: 192.168.1.3

WAN 2 IP: 200.200.2.2

Gateway: 200.200.2.1

One-to-One NAT as below

Public: 200.200.2.3 > Private: 192.168.1.x

Public: 200.200.2.4 > Private: 192.168.1.y