Hi!
I've followed the guide in the manual for creating a group VPN on the RV082 router and I am using QuickVPN v1.4.2.1, Windows 7, however the connection never completes (although the management pages shows the user as connected during the connection attempt).
2018/10/30 16:27:00 [STATUS]Connecting...
2018/10/30 16:27:00 [DEBUG]Input VPN Server Address = [FQDN]
2018/10/30 16:27:00 [STATUS]Connecting to remote gateway with IP address: [IP Address]
2018/10/30 16:27:01 [STATUS]Remote gateway was reached by https ...
2018/10/30 16:27:01 [STATUS]Provisioning...
2018/10/30 16:27:10 [STATUS]Success to connect.
2018/10/30 16:27:10 [STATUS]Tunnel is configured. Ping test is about to start.
2018/10/30 16:27:10 [STATUS]Verifying Network...
2018/10/30 16:27:16 [WARNING]Failed to ping remote VPN Router!
2018/10/30 16:27:19 [WARNING]Failed to ping remote VPN Router!
2018/10/30 16:27:22 [WARNING]Failed to ping remote VPN Router!
2018/10/30 16:27:25 [WARNING]Failed to ping remote VPN Router!
2018/10/30 16:27:28 [WARNING]Failed to ping remote VPN Router!
2018/10/30 16:27:31 [WARNING]Ping was blocked, which can be caused by an unexpected disconnect.
2018/10/30 16:28:18 [STATUS]Disconnecting...
I can ping the router via command line from the same machine, so I don't know why I'm getting that message. There is NOTHING in the VPN log on the router and the entries in the Firewall and Access logs show no rejections, only accepted connections. I have used the defaults suggested by the router. Please help debug this problem further!
