We have 2 different isolated networks, both sharing the same address space (172.30.8.xxx) and we want to join both using a RV110W, allowing only certain devices from one network access to certain devices of the other network, plugging network 1 to one LAN port (port 1) and network 2 to wan port.
I try configure it in gateway mode (I understand may be in this mode), and try to create an access rule in order to allow traffic from one device from the network 1 to another of the network 2, but the configuration page don't allow me to write the destination IP (says invalid IP address).
After that and trying to test, I also created a a rule allowing all incoming traffic and another allowing all outgoing traffic, but i can't make a ping neither a telnet to a concrete port (502) from network 1 to network 2.
Thanks in advance.
