RV110W Log Access Rules

[jeffschneider1]

Have allow all traffic for 2 IP addresses.  Have logging on and marked the rule LOG ALWAYS and never see any recorded events in the log.

I know there is traffic to these addresses.

[jeffrrod]

Dear Jeff,

Thanks again for reaching the Small Business Support Community.

Notice that even you enable the access rule log, you must globally enable logging from the

"Administration > Logging > Log Settings"  menu before you get the actual logs.  Please refer to page 124 of the admin guide for a step by step guide if needed;

http://www.cisco.com/en/US/docs/routers/csbr/rv110w/administration/guide/rv110w_admin.pdf

I'll be looking forward to your reply and thank you for your time and patience,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

[jeffschneider1]

Jeffrey.

Thanks for looking into this.  We get the logs in good order except that ALLOW traffic is not in the log.  All the DENY traffic and a large amount of debug information IS in the log and visible.

Thanks

Jeff

[jeffrrod]

Hello Jeff,

Thank you for the update.

What firmware release version you are running on?

Thanks again,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

[jeffschneider1]

Jeffrey,

Firmware Version:1.2.0.9

Jeff

[jeffrrod]

Jeff,

I am afraid all I can suggest you at this point is to call the Small Business Support Center for assistance; I am not aware of any bugs or related problems with that firmware,

https://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

And please let me know if there is anything else I may assist you with in the meantime.

Thank you,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.