Hi !
My RV110W reports wrong SNMP ifSpeed and ifHighSpeed values for eth0, vlan1 and vlan2 ( 10 Mbit/s instead of 100 Mbit/s ) for . This causes my SNMP management software to malfunction ( graphics are capping out flat at 10 Mbits/s ). ifSpeed and ifHighSpeed values are read-only, there is no way to correct that through SNMP.
I thought that maybe these values where dynamically adjusted under load, but they don't change.
I looked through the RV110W WebGUI for maybe a misconfigured interface ( 10Mbit/s instead of 100Mbit/s ), but didn't find anything like this.
Beside, eth1 and br0 get unset values ( 0 ).
Does anybody know what is happening here ?
Thanks