RV130W Site-to-Site VPN Setup

[Robert Wagstaff]

I was a little confused on the setup of a site-to-site vpn tunnel on the RV130W router. There are three IP addresses in question. The Remote Endpoint I understand to be the WAN IP of the Remote Site. My confusion is the Local Traffic Selection and the Remote Traffic Selection. What is the difference between "Subnet" and "Single" and what should the IP addresses be? See screenshot.

[Robert Wagstaff]

Since I want both entire networks to communicate with each other I am thinking the settings should be "SUBNET" and 192.168.1.0 and 192.168.12.0 respectively. Does this sound right?

Thank you

[anasathy]

Hello Robert Wagstaff,

Thanks for contacting Cisco support community centre.

I hope you are doing well. I am really sorry for inconvenience caused and delayed response.

Yes. You are correct.

Example:

Local IP –subnet

IP address- 192.168.1.0

Subnet mask- 255.255.255.0

Remote IP – subnet

IP address- 192.168.2.0

Subnet mask- 255.255.255.0

If you face any Issues in the VPN connection please reach out our SBSC team and raise service request to proceed further.

You can contact our SBSC team via chat with the help of below links:

https://supportforums.cisco.com/community/4841/online-chat-support

Please check this out and let me know if there is any further assistance I may help you with.