I'm very confused by the RV215W settings. I'm comparing this to the RV042 as a point of reference because the RV042 does what I need. I figure that the RV215W would be more or less the same but now I wonder....
I read this in the Access Rules HELP:
The default inbound policy for traffic flowing from the non-secure zone to the secure zone is always blocked and cannot be changed.
Then in the Access Rules one can select
Connection Type Inbound WAN>LAN and Action Always Allow.
So the first one contradicts the second one.
However, the second one only allows a single destination IP on the LAN which is NOT what one needs for general VPN passthrough type of operation.
What's the answer?
