Hi,
I have purchased one last April the RV220W router. I was very happy until then.
It is in the center of my gigabit network, divided into three VLANs:
- one for my computers,
- one for my NAS,
- one for my servers.
But I discovered a serious problem that prevents me from using my equipment:
- When I start a transfer of 4Gbit from my PC A to my NAS (Vlan1 to Vlan2)
- And, in same time, I start another transfer from my NAS to my PC 1 (Vlan2 to Vlan1).
The router is crashing and not responding, I cannot access to the router, the network is broken, Internet and others vlans are unreachable.
After few minutes, Internet and Vlans are available again, but not my router, I must reboot it manually.
I tested several configurations, no change. The new firmware (1.0.4.17) has not effects either.
Thanking you for your help
Best regards,
Richard Déloge.
