Routers - Small Business

Hi,We bought a RV220W in order to get a VPN in our Small Business. The RV220W will only be used to let clients connect to it and not a tunnel between another VPN box.We could use QuickVPN, but it won't be working in our case, because in order to use ...

Hi,Due to various reasons, I need to configure a new RV042 behind a SSG5 firewall. All VPN connections is client to gateway.Firstly, i tried doing a direct connection(bypassing the firewall), the quickVpn status says connect but I can't even ping the...

We have a cisco router on the lan, behind the WRVS4400n. It has a config that has connected many times before, sucessfully to an ASA through Ezvpn. I see on the ASA logs that phase 1 connects fine, then I see this message "received encrypted oakley q...

I recently purchased a RV120W router and I am having a problem selecting n speed under the wireless settings.If I select B/G/N-Mixed mode then when I go to save the change I get B/G/N-Mixed B/G/N-Mixed in red letters and it does not save.  If I selec...

Dear Forum. Occasionally we experience problems with our internet connection. We are tracing this problem for quite some time now. Due to the fact that we are little far away from the DSLAM we do not have the fastest DSL. We are trying to compensate ...

Hi, I have purchased one last April the RV220W router. I was very happy until then.It is in the center of my gigabit network, divided into three VLANs: - one for my computers,- one for my NAS,- one for my servers.But I discovered a serious problem th...

There are 6 part numbers for the RV180W router. What is the difference between them: wan access (Annex A,B ...) or other quality?Thanks for answerA.Stephan

I replace our aging rv082 routers with wireless rv220w routers. The gateway to gateway vpn works great, however I am no longer able to manage our print servers port 80 management page. I can ping any host with success, and I can manage hosts that hav...

I recently "upgraded" to Uverse from DSL. While the speed boost is nice, UVerse comes with a 2wire residential gateway that is driving me crazy. Unfortunately you can't disable the DHCP functionality in the 2wire router, nor can you disable the route...

I have installed a WRVS4400N router in a client's office.  When laptops are plugged into the router everything works fine.  When they are attached via the wireless signal it drops frequently.  WPA personal is being used to encrypt.  I have also insta...

I ma trying to setup a IPSEC site to site VPN between MS Forefront TMG 2010 to a Cisco SRP527W routerI am running the latest firmware on the routerI cannot get the 2 to connect, I have matched as best as possible the settings on the SRP527W as are in...

Hi,I have a VPN between a SRP527W and RV220W that seems to drop when more than 3 users try to use the link. I need to restart both ends before the VPN will connect again. I have read a few things about firewall settings but would like some suggestion...

Hi there,Have followed the admin guide, and can setup this up fine, however what we're wanting is to turn off any IP connection for the main wan ethernet interface and only have the sub-interface have an IP connection method.I can't see how you can t...

I have a mpls WAN setup from my telco for 6 sites and an internet feed with static ip addresses.  This is all hosted and managed by the telco.  I also have a remote site with static ip.  I have two RV220w, one at the remote site and the other at head...