11-22-2012 04:41 AM
Hello,
Just setup two RV220Ws with a IPsec VPN connection. All working well. However, I have a question regarding how to force ALL traffic from a VLAN to go thru the VPN.
IPsec from site A (EU) to site B (USA) working good. On Site A I have a dedicated VLAN that needs to have ALL traffic (internet included) be sent thru the VPN tunnel. The main purpose of this is to have internet presence as if in the USA. This is necessary to access some sites available only in USA specially for the kids -their web sites will not display content because they're not in the USA at the moment. How do I accomplish this? I tried to setup a Static Route for the VLAN but you cannot setup a 0.0.0.0 destination route.
Any help would be greatly appreciate it.
Regards,
Jose
11-22-2012 07:33 AM
Hi Jose, I could be mistaken but I do not think the RV220W supports full tunnel site to site VPN.
I do know the SSL VPN can be full tunnel.
-Tom
Please rate helpful posts
11-22-2012 07:51 AM
Hi Tom,
I was under the impression that the RV220W does support full tunnel but then again I might be mistaken. I have not used the SSL VPN yet but I will give it a try.
Thanks,
Jose
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide