Hi all.
I have a new RV260 router running on 1.0.00.16 system image.
In short. First thing I need to do is connecting to a serial console of the device. I connected my device via the serial port on 115200,8, N,1. I think my settings are correct because I see the booting process on my console. After a successful boot, I can manage my device via the web interface, but the serial console does not respond. No reaction to my input.
I am trying to use the console in order to setup subinterfaces. That is the second thing. According to the documentation, it is possible.
"
Cisco IOS software supports four types of virtual interfaces;
•loopback
•null
•subinterface
•tunnel
"
But for now, I am not sure if this (setting up subinterfaces) is possible at all on this router.