RV320 ignoring client VPN connection

[VonHop]

I've recently had to do a factory reset on my RV320 router. I'm trying to setup VPN client-to-gateway connection again. I've tried my previous configuration for using Shrewsoft VPN and even tried following setup for Greenbow VPN as well. Neither client is able to get past phase 1 setup.

I followed this video for Greenbow setup starting at the 4:00 mark: https://www.youtube.com/watch?v=MtvpESCYnrk

I've attached my configuration for it. 

Looking at the logs on the router I see the connection is coming in, but then the RV320 seems to just ignore it and VPN doesn't pick up the connection on port 500:

2024-02-23, 08:25:36 ALLOW UDP 47.XXX.XXX.XXX:500 -> 76.XXX.XXX.XXX:500 on eth1
2024-02-23, 08:25:31 ALLOW UDP 47.XXX.XXX.XXX:500 -> 76.XXX.XXX.XXX:500 on eth1
2024-02-23, 08:25:26 ALLOW UDP 47.XXX.XXX.XXX:500 -> 76.XXX.XXX.XXX:500 on eth1

I have all logging turned on, but this is the only thing that shows up in the logs. Any idea on what I'm missing here?

[balaji.bandi]

if you using greebow suggest to follow below guide that i have done some testing before :

https://www.cisco.com/c/en/us/support/docs/smb/routers/cisco-rv-series-small-business-routers/smb5748-use-thegreenbow-vpn-client-to-connect-with-rv34x-series-rout.html

[VonHop]

That is pretty similar to what I had to do, although the RV340 has more options than the RV320. Nothing stood out to be missing from my setup