RV320 inter VLAN routing not working

[sistemasadm]

Hi, I'm from Argentina and I can't get inter vlan routing

Please can you help me

PID VID: RV320-K9 V01
Firmware: v1.5.1.13 (2020-10-27, 13:37:43)
Working Mode: Gateway

VLAN Membership
---------------

VLAN: Enable

VLAN Table
                                 |            DHCP Setup                              |
ID | Routing |LAN1|LAN2|LAN3|LAN4|    IP    | Subnet Mask   | Start      | End        |
 1 | Enable  | U  | T  | T  | T  | 10.0.0.1 | 255.255.255.0 | 10.0.0.100 | 10.0.0.149 |
 2 | Enable  | T  | U  | E  | E  | 10.0.1.1 | 255.255.255.0 | 10.0.1.100 | 10.0.1.149 |
 3 | Enable  | T  | E  | U  | E  | 10.0.2.1 | 255.255.255.0 | 10.0.2.100 | 10.0.2.149 |
 4 | Enable  | T  | E  | E  | U  | 10.0.3.1 | 255.255.255.0 | 10.0.3.100 | 10.0.3.149 |

U -> Untagged | T -> Tagged | e -> Excluded

Need:

Devices on VLAN 1 can see devices on VLANs 2, 3, and 4

Devices on VLAN 2 can see devices on VLAN 2

Devices on VLAN 3 can see devices on VLAN 3

Devices on VLAN 4 can see devices on VLAN 4

Thank you

[Flavio Miranda · Accepted solution]

Hi @sistemasadm 

RV320 is a router, this means, if you create two interfaces vlan on the router, intervlan routing should work automatically. But, in order to accomplish what you need, you need to use Access List. Take a look on this video and let me know. This is for RV34X but must apply to yours also.

https://www.youtube.com/watch?v=93OnQI8ToGo

[sistemasadm]

##- Flavio Miranda, your contribution was very helpful for me. Thank you very much, regards, sistemasadm -##

[Flavio Miranda]

You are welcome. Thanks for rating.