05-03-2017 05:41 AM
Hello,
I have three RV320's connected in a full mesh of multiple LANs on each side. 9 tunnels are configured on each RV320 to interconnect the three sites. Once the VPN's are configured using keep-alives, and all proper parameters, the tunnels come up and stay connected. Traffic works as expected and there are no issues once things get established.
However, after some time, lets say after several hours of being connected, the tunnels just stop forwarding traffic. The status remains connected, but as I setup continuous pings across the tunnels, the traffic just stops being forwarded.
Any ideas as to why the tunnel would stop forwarding traffic when the tunnels remain up? Is this a certificate validity issue? Dead-peer issue? Defect?
Anyone else come across this issue?
05-03-2017 05:51 AM
For further clarity, I have upgraded to the latest image as of May 1, 2017. I have also reset to factory default and rebuilt all the tunnels from scratch.
RV320 firmware version is: v1.3.2.02 (2016-09-23, 15:17:06)
03-03-2019 08:07 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide