Admittedly I'm very new to this, so please forgive if I'm not using the correct terminology.
As a result of the pandemic, I've been thrown into setting up a site-to-site VPN. To that end I ordered 2 RV340 routers.
Neither site has dynamic public IP addresses. I created two dyndys host names (one for each site) and linked the local site public IP addresses to those host names.
I thought I had the VPN settings correct, but obviously something is wrong because the the tunnel is not connecting.
I've attached pictures of the setting on the remote RV340. The other RV340 is configured with the same, but reversed for local and remote. The IKE key is copy and pasted, I'm certain it's correct on both sites. Am I missing something obvious?
Any help would be appreciated.
Thanks,
Dave
