RV340 VPN Client don't see LAN network

[MarceloRaffo62972]

I was setup SSL VPN. on my RV340

Mandatory Gateway Settings
Gateway Interface: WAN1
Gateway Port: 8443
Certificate File: Defaul
Client Address Pool: 10.11.12.0
Client Netmask: 255.255.255.0

My LAN/DHCP Settings

IP Version 4
DHCP Mode: server
Address Range: 192.168.10.100-192.168.10.199
Prefix Length: 24
DNS Server:

subnetmask 255.255.255.255

I managed to make a perfect connection from my vpn client.

But from the VPN client I do not see the local network of 192.168.10.0, I do not see any local pc for example in the address 192.168.10.102.

I understand that it is because I made a mistake and put Client Address Pool: in 10.11.12.0 instead of placing it in 192.168.10.0, but when I want to correct this and place it in

192.168.10.0 it tells me Subnet range error

Can someone tell me what I am doing wrong or what I should change ?

thanks for any advice

[balaji.bandi]

you can use a different subnet for VPN Pool 10.11.12.0 - like you used, make ACP rule to allow 10.11.12.0 to 192.168.10.0 and test

[MarceloRaffo62972]

Excuse me but I don't know what ACP rule is.

I don't understand how to make a subnet for the VPN Pool.

Forgive my ignorance, I am not that knowledgeable in network technology.

I understand that a clace C IP address is 192.168.xxx.xxx and that the netmask should be 255.255.255.255.0.

I thought that by setting my DHCP on 192.168.10.100 to 199 and the surber mask 255.255.255.0 on my LAN, I should only put 192.168.10.0 in the VPN Poll, but evidently I don't understand something.