RVS4000 and DHCP address

[k1200ltrdr]

I have 2 RVS4000's Version:V2.0.0.3 that aquire thier IP via comcast dhcp.

They work fine at the sites but when I look at the status, both report that thier IP's are 10.1.10.x range and that is not a comcast address.

I suppose that wouldnt be an issue, except that it tells DynDNS.org that nonrouting 10.1.10.x is its address and it's hardcoded into the IPSec setup so I can't get a VPN working to connect to a 3rd site (with static IP).

Anyone help greatly appreciated.

[k1200ltrdr]

Anyone?

[daviddun · Accepted solution]

Good Morning,

Comcast needs to move their device to a bridge mode and give you the public IP onto the RVS4000

I have had this happen a lot and it just requires a quick phone call to the Comcast support desk

I hope this helps

[k1200ltrdr]

As soon as I read your response I felt like an idiot. Of course that's what it is. I'd forgotten the comcast modems NAT'd.

Thank you so much.