We have an RV180 and can not get connected to a port on CPE equipment after setting the WAN port on the RV180 to 100/Full.
The CPE equip port is set to 100 Mb/Full Duplex. When the port on the RV180 WAN is set to AUTO and we connect to the CPE we see a lot of CRC errors and very poor performance. When we set the RV180 WAN Port to 100/Full we see no traffic at all.
We have a Cisco ASA 5150 router connecting to the a different port on the same CPE and when we set its port to 100/Full we see very good performance.
We have upgraded the RV180 to the latest FW (1.0.3.10) but that didn't solve the problem.
Can anyone provide assistance with setting the WAN port to 100/Full with success?
Thank you,
John
