Hello,
My current setup is with two RV042 routers that are in Gateway to Gateway VLAN. I am able to ping the different subnets after putting them in the router under setup>network. I am not able to use an application on one of the subnets.
Router 1
WAN 10.0.0.1/29
LAN 192.168.3.250/24
Router 2
WAN 10.0.0.4/29
LAN 192.168.5.250/24
Subnets of:
192.168.2.2/24
172.20.25.1/30
I am needing to access the 172 network to use my application. When I type in the 172.20.25.1 address in a browser, trying to access the unit that way, I keep getting the log on screen for router 2. It looks to me that router 2 is not letting the traffic get past it to my device that my application is trying to talk to.
I am new to setting up VPN's between offices, so I am not sure where to go from here. Do I need to some how inter Vlan these subnets?
Thanks
Brian
