About briangreig

briangreig · 07-17-2017

Hi all, I have some 3560's that are in service that need to be swapped out with 3750's. Is there a way to copy over the current configs from the 3560's to the 3750's without having to rebuild the config files from scratch? Thanks Brian

briangreig · 06-28-2017

Hello, I am attempting to join a two separate networks together to allow my works VOIP system to travel along both networks, while keeping each network separate from each other. Network 1, static network, has the PBX on it that I need to allow acces...

briangreig · 03-23-2017

Hello, My current setup is with two RV042 routers that are in Gateway to Gateway VLAN. I am able to ping the different subnets after putting them in the router under setup>network. I am not able to use an application on one of the subnets. Router...

briangreig · 02-26-2017

Hi all, I am working on my home lab to study and play around. I have a 2811 router that I am using for CME purposes only, no outside wan access. This was hooked to a switch and then two Cisco phones. I was able to make calls between the phones and...

briangreig · 02-10-2017

Hello, To start I am experienced in networking and studying for my CCNA, but I am not a pro at all things Cisco when it comes to setting up from scratch. I live mostly in an environment where things are already up and running. I am trying to build a...

briangreig · 07-26-2017

Quick question, I rebuilt the config files on my spare 3750 for each different switch and saved each config file. When I went to upload the new config files to the switches I needed to change, vlan2 and vlan3 stay down. Is there something I am miss...

briangreig · 07-20-2017

HTH, Thank you for the help. I ended up redoing it any way. When I uploaded the newly configured file to another switch however, the switch isnt allowing vlan2 or 3 to come up now. Not sure what I messed up. I will post the config in a bit. Tha...

briangreig · 07-12-2017

Dennis, Ok so I have been trying to mock up my configuration in Packet tracer so I can experiment. I have gone through a redo of my configs. I now have three switches, Two with two vlans and one with three, the three vlan switch is the interconnect ...

briangreig · 06-30-2017

Dennis, Im at home now, I will grab the config on monday and post it. I was able to use a spare switch and mock up the network in the shop. On port 4, I was able to assign the acl to only pass the 192.168.3.0 network and it seems to be working, all...

briangreig · 06-30-2017

Ok, after sitting down and mulling this over I might have a solution but need to see what you guys think. I only want the 192.168.3.0 255.255.255.0 network to be able to pass back and forth on the port that interconnects two networks, lets say fa1/0/...

Member Since	‎02-09-2017 11:56 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	17

User Statistics

User Activity

Copy config to different model switch

Deny traffic from different vlan's

Traffic across VPN on multiple subnets

Data and Phone vlan seperate on single switch

Need help with setting up network

Quick question,

HTH,

Dennis,

Dennis,

Ok, after sitting down and