05-20-2005 09:44 AM - edited 03-03-2019 09:37 AM
I have a 2620 and I am trying to add a 2FW/2W card to add a couple WICS. When I boot the power light shows on the card but when IOS loads they do not show up in the running config.
Any suggestions?
05-20-2005 09:48 AM
Check your version of IOS in the configuration matrix on the main Cisco site.
Usually when hardware is not discovered, it's either: 1) the hardware is not properly seated (reseat the modules and make sure the screws are tightened) or 2) the version of IOS does not support the hardware (hence: it can't identify it).
Good Luck
Scott
05-22-2005 04:00 AM
NM-2FE2W is 100% compatilbe with Cisco2620 see http://www.cisco.com/warp/public/471/wics.html
Steven Mazabow
05-22-2005 07:21 AM
You are wrong steven,
NM-2FE2W is NOT compatible with cisco2620. It clarely states it in the link you provided.Apart from that, i have personally tried it before.
femmy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide