Hi,
I'm having problem configuring the privilege mode of the 2960 catalyst, every time i configure the command:
IOS: "flash:c2960-lanbase-mz.122-25.SEE2/c2960-lanbase-mz.122-25.SEE2.bin"
username test privilege 5 secret test
privilege exec level 5 show cdp neighbors
privilege exec level 5 show cdp
privilege exec level 5 show proc cpu
privilege exec level 5 show proc cpu history
privilege exec level 5 show proc mem sorted
privilege exec level 5 show proc cpu sorted
privilege exec level 5 show history
privilege exec level 5 show history all
privilege exec level 5 show log
privilege exec level 5 show redundancy
privilege exec level 5 show running-config
every time i login the username "test" and run the command "show run" i am only getting this result
SW#sh run
Building configuration...
Current configuration : 13 bytes
!
!
!
!
end
SW#sh run full
Building configuration...
Current configuration : 13 bytes
!
!
!
!
end
the only options are:
SW#sh run ?
brief configuration without certificate data
full full configuration
interface Show interface configuration
| Output modifiers
<cr>
What to config to view the full "show run" command
Thank you so much!